Ways To Trim Your Split Ends

Which Split End Trimmer Is Best

The appearance of your hair being damaged and dry can be caused by split ends. The good news is that there are very simple methods for getting rid of those annoying split ends, which will leave your hair looking healthy after you trim it for just a few minutes. Try twisting or sliding your fingers along a segment of hair to uncover the damaged ends.

Methods for Trimming Your Split Ends

1 Dusting

This technique, which is commonly referred to as dusting, can be used to get rid of split ends without affecting the length of your hair. If the ends of your hair are frayed and need to be cut, you have the option of going with a basic trim, which involves using sharp cutting shears to lop off a little amount of length from your hair.

After brushing your dry hair, take off a segment that is approximately one inch (2.5 cm) in width. It is in your best interest to have dry hair in order to facilitate the visibility of the split ends. Take a part of your hair about one inch (2.5 cm) in width and hold it in your hands. If the section of hair is tangled, give it some time to be brushed out.

To expose the split ends, carefully twist the portion of hair that you want to examine. Beginning at the crown of the piece of hair, twist it as you work your way down the hair. Keep twisting the strand until the entire segment is in a very tightly twisted state. After you have twisted the hair, you should observe that the tips of some of the strands are emerging from the twist.

Trim off the split ends that are hanging out of the twisted portion. rim off the split ends. Examine the ends that are protruding from the twist; there is a good chance that the majority of them are split ends. Using the cutting shears, trim each split end to a length of around 0.5 centimeters (0.20 in), which will expose the healthy hair underneath.

2 Using a split end Trimmer

The Split Ender Pro is the best split end trimmer with no exceptions. It works the easiest, includes the two different length settings, and is the smoothest. It’s recommended you straighten your hair before using the Split Ender Pro. The Split Ender Pro guarantees a safe, fast, and easy way to care for split ends.

3 Using Shears

Your hair should be dried and styled such that it is straight. If you already have naturally straight hair, all you have to do is give it a good brush through and it should be ready to go.

If you have wavy or curly hair, it is advisable to straighten it in addition to combing it so that the split ends will show up more easily. Straightening the hair will also make the hair simpler to manage.

It is possible that you may need to just blow dry your hair instead of using a straightener if your hair naturally has waves.

Gather a piece of hair that is one inch (2.5 cm) wide and one inch (2.5 cm) long. Make sections in your hair with the help of a little comb. The increments of 1 inch (2.5 cm) are simply a recommendation; hair that is extremely thin may be able to manage a bigger piece, while hair that is quite thick may require fewer parts.

Put your hair in this position so that it is centered between your middle three fingers. Weave the strand of hair in and out of the spaces between your fingers, beginning with your index finger and ending with your ring finger. If you follow these steps, you should only be able to see your hair on the top of your middle finger.

When the piece is placed over your finger, look for the split ends that protrude outward. You should be able to see ends of your hair sticking out of the area of your hair that is visible on your middle finger if you weave your hair in between your middle three fingers. Examine the cut ends very carefully to find the ones that need to be trimmed.

As you work your way down the portion of hair with your fingertips, snip off any split ends that you find. When you hold the scissors in such a way that they are perpendicular to the strand of hair, it will be much simpler for you to cut off the split ends that are protruding out. Move your fingers carefully along the strand of hair, and continue to snip off any broken ends that you find as you go.

The amount of hair that has to be lopped off is just approximately 0.33 centimeters (0.13 inches) in length.

4 Using A Restore Shampoo Or Product

Use conditioner frequently and thoroughly so that your hair can retain moisture. Don’t forget to apply conditioner on your hair after you’ve shampooed it, and be sure to spend some extra time massaging it into the ends of your hair. There are a variety of potential causes for hair to break and split, but the most common problem is that the hair is not adequately hydrated.

If you want the finest possible results, you should condition your hair after every shampooing. Even on days when you don’t wash your hair, you may keep your strands hydrated by using a leave-in conditioner to your hair before you go to bed.

Trimming Split Ends & Hair Care Tips

What To UseWhat It Does And Tips
Split Ender PRO 2This is a cordless split end hair trimmer that is suitable for both men and women. This model has a one-quarter-inch trim setting that is fixed. It’s quick, secure, and simple to use. That is why I am drawn to this model. You can cut the ends due to the design. I do not recommend that most people do this at home, but I understand why some people do. As a result, this is the tool I recommend.
Fromm Shears 5.75 InchUse precision cutting shears like this one if you need to cut your hair at home. I like the semi-convex edge and the high-quality German steel. There are no frayed ends. It fits perfectly in your hand.
Oribe Gold Lust Repair & Restore ShampooI like it because it works at restoring dry, damaged hair by helping to seal in monitor, and protect future damage.
Oribe Gold Lust Repair & Restore ConditionerA great conditioner to go along with the Oribe Gold Lust repair shampoo. give a nice clean glossy look to your hair without overdoing it. It does not weigh hair down.
Briogeo Don’t Despair, Repair Deep Conditioning MaskAfter your shampooing, evenly apply the conditioning mask and leave it on for five minutes before rinsing. Use about once a week. But before you jump in, test on a small section of your hair first!!! Briogeo helps to protect frayed brittle ends while restoring hair.

Hey, do you have a bunch of split ends due to excessive blow drying and or curling you want to get rid of but for some reason do not want to go to the stylist for a trim? Or maybe you are one of those do-it-yourself types and would rather tackle split ends yourself. Well, whatever the case, the Split Ender Pro may be just the tool for you.

I get it some folks are just not that good with shears and would feel safer using a tool in which has the cutting head enclosed for safety. I would since you may use it close to your ears, right?

If you are chemically treating your hair then, as you may well expect, it’s just a matter of time before you will get split ends“, according to Ed. And as you know, the best remedy is to get a trim. The Split Ender Pro works by trapping your hair in a clamp and runs your hair through the rotating blade cut off the ends. This way you do not have to change the length of your hair because the tool just cuts off the ends.

To further protect you hair consider using a hairbrush like Wet Brush Original Detangler Hair Brush. It’s a detangler brush that protects against breakage, split ends and can be used on either wet or dry hair. Also works on frizzy hair.

Whatever split end trimmer you use, your hair will undoubtedly seem less frizzy and healthier as a result. As an added bonus, it will be more manageable.

What Does The SPLIT-ENDER PRO2 By Talavera Do For Split Ends?

Well, this might just be the answer to your prayers. A DIY at-home split end remover. So getting started, you will need to first have straight hair. Yea, it’s going to work much better on straight hair. And don’t forget to detangle your hair. You want your hair to be straight and tangle-free before you use the Split Ender Pro. Next, you will need to note the direction of the arrows on the brush head.

There are two buttons on the brush that control the direction of the internal blade. Press the button to activate the blade. Make sure you press the right button for going in the right direction. If you are moving the brush down, then the button pointing that way is what you want to press.

Split-Ender is a hair product that removes split ends from all types of hair, including dry, damaged, and brittle ends. Designed for people with medium to long hair. Of course, your past hair condition will have an impact on your final results.Power Adaptor: Bi-Volt 110-240 Volts. Use direct plugged in or wireless. Charge the battery before use for 3 to 4 hours.

With Talavera’s innovative Surgy Trim System, it’s easy to get a clean and accurate cut on split ends without risking injury. I found it to be used almost like a flat ion, it’s that simple. The product is delivered in a sealed and simple-to-open package. Take a look at the instruction manual and read the main steps before using.

How Does The Split-Ender Pro Work?

Using the Split-unique Ender’s patented “Hair Plate,” which is specially intended to guide hair strands into and out of the “Strand Guards” in a uniform manner, the Split-Ender safely guides each and every hair in a straight motion. When they reach the center of the hair plate, they are compelled to keep their heads straight up. The blades snip the tip of the hair by approximately (The model contains two trim settings) 1/4 &1/8 (depending on the Spacer type that you choose), trimming the ends where burned, dry, damaged hair ends and split ends are more likely to be found, while preserving and leaving the long, beautiful, and healthy hair strands unaffected by the trimming process. It does this by using their double hidden blade head with comb head length adjustment, in which can be (adjusted) done easily. It does not make your hair shorter.

How Does The Split-Ender Pro Cordless Split End Hair Trimmer Work?

At first, when you use the tool you will be scared the tool will gobble up all your hair and spit out a mess. But that is not the case. After several passes of the brush, you will be pleasantly surprised. Your hair is still intact, minus about one-quarter of an inch. The damaged tips will be removed. It will trim all tips the Split Ender Pro can’t tell which strands are damaged. It just cuts all the hair that passes through the brush.

According to Meesh, our in-house hair analyst, “The Split Ender Pro will not get rid of all your split ends but will get you going in the right direction.” And it’s safer than wielding a pair of scissors. Now you can get on with moisturizing and applying treatments to get back your healthier hair.

Simply put, it does what it claims to do and removes stray hairs that have grown past their normal length. These are most likely damaged split end from the body of your hair. They are cut without removing any of the hair from the body of your hair. I like the cordless and rechargeable feature. Plus the machine itself comes with two spacers a 14-inch trim and an 18-inch trim. Both are critical for achieving an accurate cut. The spacers are included with the machine and are required for correct cutting. As you probably anticipated, detangling your hair properly before utilizing the machine is a must for successful use.

How Does The Split-Ender Mini Work?

In addition to the Split-Ender Pro There is Split-Ender Mini.

With the Split Ender, you can get rid of split ends in your hair. The Mini is suitable for all hair types and specifically designed for people with medium to long hair. Your past hair condition may have an impact on the final results. the Mini uses the Talavera patented Surgy-Trim System, which allows for a precise and safe cutting of split ends.

The Mini is a cordless and battery-operated (3 AAA batteries included), this surprisingly quiet, travel-friendly tool and comes with everything you need, including a deluxe carrying case, instruction booklet, cleaning brush, style comb and sectioning clip. Packaging that is both sealed and simple to open.

I found in order for the product to function properly, it must be powered by brand new batteries. A full description of practical information for the operation of the Split-Ender product is provided in the hair, Split-Ender user manual contains detailed explanation, for the tool. I believe you will benefit from the handbook since it will teach you the important steps and procedure to take before using the Split-Ender. Also I think is very critical is care must be taken to keep the unit in good condition. Also in the manual is how to troubleshoot the device.

What Is The Proper Way To Use A Split End Trimmer?

  1. Make sure your hair is clean and dry before you begin. Before you begin, refrain from using any conditioners or other products. you hair should be free form any styling products.
  2. In order to use the split end remover effectively on curly or wavy hair, it is best to straighten it first. The results will be more consistent in this manner.
  3. Make little strands of hair out of your hair. I advise using thin sections.
  4. Open the hair plate and select the arrow that corresponds to your hair type (it needs to point to the floor).
  5. Make sure you have your hair clamped in the trimmer and carefully run it along the length of it.
  6. Repeat the process of running over the same strand as many times as necessary. Although the instructions say to repeat the process three times, I’ve had to repeat it a couple of times more on very dry regions of hair.

What Are The Results After Using A Split End Trimmer?

Not only did hair feel softer, but it also seemed glossier, and the tester’s split ends were reduced. Looking at both, at the bottoms and throughout the shorter layers split ends were definitely reduced if not all eliminated. Despite the fact that the machine did not remove every single split end, I would estimate that between 60 and 80 percent of split ends were eliminated, depending on the type of hair of course. It took approximately 30 minutes to do an entire head of medium to thick straight hair. And it took approximately one hour to do an entire head of very thick curls. The times of course were based on first time using the tool. I am anticipating after using the tool several times and getting use to the feel of how it operates times will be better. After use I recommend using a split end trimmer.


Van Meter, M., Mao, Z., Gorbunova, V., & Seluanov, A. (2011). Repairing split ends: SIRT6, mono-ADP ribosylation and DNA repair. Aging (Albany NY), 3(9), 829. https://www.ncbi.nlm.nih.gov/pmc/articles/PMC3227448/